Nebulizer Eye Mask Eye Medication Device

[Instructions]

1. Remove the product and inspect it for damage. Connect one end of the bellows to the inlet of the eye applicator and the other end to the atomizer.

2. Turn the atomizer direction knob on the eye applicator to the left, right, or both eyes as needed.

3. Wear the product, ensuring the soft rubber part is in contact with the skin around the eye. Turn on the atomizer to begin atomization.

4. After atomization is complete, remove the applicator and turn off the atomizer. Clean the applicator and allow it to dry.

[Main Structure] Consists of an eye mask tray, adjustment plate, positioning post, assembly carrier (including the inlet), elastic band, eye mask soft rubber, and delivery tubing.

This is a reusable, non-sterile product. It must be used with a nebulizer cup. Connect one end of the delivery tubing to the nebulizer cup and the other end to the inlet.

[Scope of Use] For administering medication to the patient's eyes. This product does not contain medication, has no atomization function, does not have a dose control function, and is not intended for subcutaneous or intravenous administration.

[Contraindications] None.

[Precautions]

1. Do not use if the packaging is damaged.

2. Do not use if the product has exceeded its expiration date.

3. This product is not sterile and is reusable. During first use or repeated use, follow the cleaning and maintenance instructions specified in the product instructions.

4. If the soft gel or accessories become yellow or deformed after repeated use, replace the eye applicator immediately.

5. Minors must be supervised by an adult when using this product.

6. To avoid cross-infection, it is recommended not to share this product with others, including family members.

[Product Cleaning and Maintenance]

To ensure the continued effectiveness of the product, it should be cleaned and maintained after use. Hot water immersion is recommended for general household use, while alcohol disinfection is recommended for general medical institutions (refer to GB15982-2012 "Hospital Disinfection Hygiene Standard"):

1. Hot Water Immersion: After atomization, rinse the inside and outside of the product with clean water. Then, completely immerse the product in hot water (60°C-80°C). Soak for 10 minutes, then remove it. Remove it from the water with a clean cloth and allow it to air dry.

2. Alcohol Disinfection: After atomization, rinse the inside and outside of the product with clean water. Remove it with a clean cloth and allow it to air dry. Then, spray or wipe the inside and outside of the product with 75% alcohol. Leave it on for 3 minutes, then wipe it dry with a clean, dry cloth. Note: Alcohol is flammable. Avoid sources of fire when using alcohol disinfection.

Those allergic to alcohol should use this method with caution.